Mipro ACT-30T Bodypack Transmitter User Manual

Specifications and design subject to change without notice. MN 014/03All rights reserved. Do not copy or forward without prior approvals MIPRO.A

1415Bodypack Transmitter Bodypack TransmitterAUDIOSHIELD4321PINSHIELDAUDIOBIAS34PIN12AUDIOSHIELD1432PINSHIELDAUDIO321PIN4321SHIELDAUDIO1342PINAF In

Battery Removal and InstallationPushing down both snap locks on the sides to open battery compartment cover. Take out the two batteries. (Figure 3) I

1. Read these instructions. 2. Keep these instructions.3. Heed all warnings. 4. Follow all instructions. 5. Do not use this apparatus near water. 6. C

01Bodypack Transmitter Bodypack Transmitter1 Bodypack Controls and Indicators3 O Display Screenransmitter Parameters12 Battery Status1315 AFattery R

Antenna: Flexible 1/4 wave transmitting antenna.Transmitter Housing: Holds PCB board and wires.LCD Panel: Display transmitter parameters. SET Button:

Group and ChannelFrequency Sensitivity LevelRF Output PowerFrequency BandMUTE ModeParameters Lock & Unlock StatusBACDEFGTransmitter ParametersMODE

! Frequency Band, Group & Channel and Frequency are factory pre-set, thus, its parameter values are displayed after it is ACT synced. Values canno

Setting RF Output Power! 2 RF Output Power Levels: RF-LOW and RF-HI.! Press MODE button until RF POWER LOW or RF POWER HIGH mode appears.! Press SET b

Setting LOCK1011Bodypack Transmitter Bodypack TransmitterLOCK SET LOCKUNLOCK SET LOCKSETLOCKED RF POWERRF-

1213Bodypack Transmitter Bodypack TransmitterGEADBCMUTE Control Set-UpMUTE control enables audio to be muted or un-muted temporarily.Press MUTE butt