Mipro ACT-72TC Rechargeable Narrowband Bodypack Transmit User Manual

Browse online or download User Manual for Receivers and Amplifiers Mipro ACT-72TC Rechargeable Narrowband Bodypack Transmit. MIPRO ACT-72TC Rechargeable Narrowband Bodypack Transmitter User Manual

  • Download
  • Add to my manuals
  • Print
  • Page
    / 11
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 0
ACT-71TC / ACT-72TC
Rechargeable Bodypack Transmitter
User Guide
Specifications and design subject to change without notice. MN 014/03
All rights reserved. Do not copy or forward without prior approvals MIPRO.
2 CE 5 1 4 A
Page view 0
1 2 3 4 5 6 ... 10 11

Summary of Contents

Page 1 - User Guide

ACT-71TC / ACT-72TC Rechargeable Bodypack TransmitterUser GuideSpecifications and design subject to change without notice. MN 014/03All rights res

Page 2 - Connections)

Battery Removal and Installation! Pushing down both snap locks on the sides to open battery compartment cover. Take out the two batteries. (Figure 3)!

Page 3 - Operating Instructions

1819THIS DEVICE COMPLIES WITH PART74 OF THE FCC RULES AND RSS-123 ISSUE 2 OF CANADA. OPERATION IS SUBJECT TO THE FOLLOWING TWO CONDITIONS: (1) This de

Page 4 - 775.275MHz

01Rechargeable Bodypack TransmitterContents1 Bodypack Controls and Indicators3 O Display Screenransmitter Parameters11 Battery Status15 AFattery Remov

Page 5

MUTE Button: To mute and un-mute the audio signal temporary.Antenna: Flexible 1/ 4 wave transmitting antenna.Transmitter Housing: Holds PCB board and

Page 6 - MANUAL

LCD Display ScreenLCD ScreenAF (audio) MUTETransmitter Battery Meter A1A2A3A1A2A345 AF MUTE775.275MHz FREQUENCYTransmitter Parameters!P

Page 7 - OFF

! Group & Channel and Frequency are factory pre-set, thus, its parameter values are displayed after it is ACT synced. Values cannot be changed.( )

Page 8 - MUTE

Setting RF Output Power! 2 RF Output Power Levels: RF-LOW and RF-HI.! Press MODE button until RF POWER mode appears.! Press SET button once to activat

Page 9 - External Mute Connector

Setting LOCK! Setting LOCK can be switched to LOCK or UNLOCK mode.! Press MODE button until SET LOCK mode appears.! Press SET button to select the des

Page 10 - (Figure 4)(Figure 3)

ERR Message ! When “ERR” appears in the display it indicates that an operational error has occurred. Please refer to the following codes to diagnose w

Page 11 - & IC - ID

External mute connectorExternal Mute ConnectorMJ-70 External Mute Switch (optional)! External mute connector is a 3.5mm jack. When an external mute sw

Comments to this Manuals

No comments